Home > Product > Highway Guardrail Roll Forming Machine > 2 Waves Highway Guardrail Roll Forming Machine

Cheap 2 Waves Highway Guardrail Roll Forming Machine

Equipment Overview: The equipment is an automatic production line that make highway guardrail by galvanized strip through uncoiling, leveling, punching, roll forming, cutting. It can produces two-wave guardrails. Process: Feeding (Manually) - Leveling - Encoder length Hydraulic punching - Roll...
Product Details:

Equipment Overview:

The equipment is an automatic production line that make highway guardrail by galvanized strip through uncoiling, leveling, punching, roll forming, cutting. It can produces two-wave guardrails.


Process:

Feeding (Manually) - Leveling - Encoder length Hydraulic punching - Roll forming - Straightening - Measuring length - Hydraulic automatic cutting - Discharge (Manually)


Features:

1. Roll forming passes layout scientific and reasonable. The range of soft and hard degree of galvanized steel strip is wide for this equipment. It is not easy to damage the zinc layer of galvanized strip in the rolling process.

2. It can use strip to punch, and then form continuously and cut off length, to ensure dimensional accuracy. Or it can use sheet to feed and form without cutting off. Ensure the accuracy of the connection hole, high productivity.

3. Hydraulic stop to punch, roll forming, tracking cut off.

4. Operator needs one worker.


Technical Parameters:

1. Production speed 0-15 m / min adjustable

2. Can meet a variety of different specifications of the highway guardrail profile forming.

3. Rolling thickness: 3-4mm

4. Profile cutting springback opening ≤ 2mm


Operation method

1. Select the leveling table and stabilize the machine so that the chassis can be pulled apart to make the machine panel easier to observe.

2. Insert the plug on the hand-held sensor head into the socket on the panel and tighten it. Attention to positioning gap

3. Plug one end of the power cord into the socket on the rear panel of the chassis and the other end into a power supply socket. Be sure to use a single-phase three-wire power supply.

4. Open the "POWER SW." on the rear panel of the chassis and press the "SWITCHING" button on the panel until the "WARM UP" "green indicator light is on, the machine can work.

5. Hold down the SETTING BUTTON button and set it to a suitable value, typically between 0.5-2.0 seconds.

6. Place the sensor head on top of the container lid and press the start button on the handle. The "HEATING" red indicator light is on, indicating that it is heating, the sensor head should not be removed, and the "HEATING" red indicator light is off. Then remove the sensor head and wait for the "WARM UP" green indicator to light up or the internal buzzer to beep once to indicate the next container seal.

7. Check the quality of the seal. According to the different materials, diameters of the container and production efficiency, properly modify the "SETTING BUTTON" key, so that the best sealing quality.

Hot Tags: cheap 2 waves highway guardrail roll forming machine, China, suppliers, factory, customized
Related Products
Feedback: